Publicidad
Idiomas disponibles
Idiomas disponibles
Plantillas de Vitrocerámica
⚫ Carry out all cutting of the unit and work surface then carefully remove
shavings or sawdust before inserting the appliances.
⚫ To ensure the correct ventilation of the hob, please comply with the
dimensions shown in the figures.
⚫ Always refer to the manufacturer for specific instructions,
⚫ Make sure the surface is level and square and that no part interferes with
the space required for installation.
⚫ Prepare the cut as indicated (see installation dimensions).
WARNING
Risk of cutting.
Be careful of cutting edges.
End parts in foamed plastic - be careful.
During transportation these could cause slight injury or cuts.
Remove the material and envelope of documents from the packaging.
Before proceeding with installation read the work instructions carefully.
Step.1
Put a towel or cloth on the work surface. Place the
hob face down on the protected surface.
Step.2
Apply the strip seal, supplied with the hob, which is
for sealing it onto the work surface.
Do not use silicone. Apply the seal to the edge of
the bottom of the hob, leaving about 3mm from the
edge of the glass.
Apply the seal all around the circumference.
Cut any excess and bring the two ends of the seal
together so they match.
www.derkochline.com
Ceramic Hob
42
Publicidad
