Publicidad
Idiomas disponibles
Idiomas disponibles
Plantillas de Vitrocerámica
Step.3
Fix the brackets (4 pcs) on the front side and rear side by screw. Put the hob
in the cut-out cabinet, and make it centre. Ensure that the front edge of the
hob is parallel to the side edge of the work surface.
⚫ IMPORTANT: You must observe the ventilation
requirements shown in the drawing opposite.
⚫ IMPORTANT: There are ventilation holes around
the outside of the hob. YOU MUST ensure that
these holes are not blocked by the work top, when
you put the hob into position (see drawing
opposite).
⚫ IMPORTANT: Do not use a silicon sealant to seal
the appliance against the aperture. This will make
it difficult to remove the hob from the aperture in
future, particularly if it needs to be serviced.
⚫ Carefully turn the hob back over and then gently
lower it into the aperture hole that you have cut out.
Fitting guidelines
2
1
The ceramic hob is manufactured to work with one-
phase alternating current. The voltage rating of the
ceramic hob heating elements is 220-240V. Adapting
the ceramic hob to operate with two-phase current is
possible by appropriate bridging in the connection
box according to the connection diagram below. The
connection diagram is also found on the cover of the
connection box.
www.derkochline.com
Ceramic Hob
43
Publicidad
