MEGABRAS MD-5060x Manual De Uso página 13

4. Connecting the equipment
ATTENTION: For a safety operation the procedures detailed below
should be carried out with the device Powered-Off.
Check if there is no differences of potential voltage between the points
where the equipment shall will be connected to, nor between them and
the ground.
Use only the accessories / test leads supplied by the manufacturer.
Using accessories / test leads not provided by the manufacturer may
compromise the equipment safety.
Connect the red security terminal (red cable) to the insulation tester (-V)
output terminal. Connect the black test lead to the zero reference (+R)
terminal and the "alligators" terminals to the element to be measured as
indicated in the figure below.
The test leads in the picture are illustrative.
14