Publicidad
Idiomas disponibles
Idiomas disponibles
When operating the power tool, certain procedures must be
taken into consideration in order to avoid loss of control of
the tool and workpieces, damage to the work area and
injury to the user.
▪ The maximum rotation speed of the machine must not
exceed that of the blade. If this does happen, the blade
may become damaged;
▪ Never start the saw when the blade is touching the
workpiece. The blade should only touch the workpiece
after the maximum rotation speed has been reached;
▪ Never perform cuts without the kerf plate fitted on the
cutting table;
▪ Ensure that in the lowest position, the blade does not
come into contact with the cutting table;
▪ Always use the clamp to secure the workpiece during
cutting. Unclamped workpieces can be thrown out at
high speeds, causing serious injury;
▪ Do not use this combined circular saw to cut pieces that
are too small to be held by hand;
▪ Cut only one workpiece at a time;
▪ Before starting any cut, ensure that the cutting area is
completely clean. Pieces of wood, touching the blade
can be thrown out at high speed, causing serious injury;
▪ Avoid cutting pieces of wood that are deformed or too
bent. These pieces can move during cutting and cause
the blade to warp;
▪ Never cut pieces containing nails or other metal objects;
▪ When changing the bevel or mitre angle, before cutting,
ensure that the blade does not touch any metal parts
during cutting. Without switching the power tool on and
with no workpiece in place, carry out a full simulated cut
to ensure that there is no interference;
▪ After completing the cut, release the "ON/OFF" switch,
hold the cutting head down and wait for the blade to
come to a complete stop before removing the workpiece.
Keep your hands away from the blade and cutting
area while the blade is rotating, the blade can
kickback towards your hand and cause serious injury.
The machine must be transported with care to avoid
accidents and damage.
▪ Set the machine to table saw mode;
▪ Ensure that the blade is fully protected, and the power
cord is unplugged;
▪ Lift the machine carefully and move it slowly without
bumping or sudden movements. Do not move the
machine by pulling on the power cord or other parts.
1. Ensure that the angular rotation shaft is fixed;
2. Ensure that the miter locking handle (22) is tightened;
3. Set the machine to table saw mode;
4. Carry the combined circular saw by its carrying handle.
This combined circular saw can be used as a miter saw or
as table saw.
The saw is factory supplied in table saw mode.
To use as miter saw, proceed as follows:
1. Remove the miter gauge fence (6);
2. Loosen the two clamping knobs of the worktable (16);
3. Raise the table and tighten the knobs;
4. Pull out the head lock-down pin (17);
5. Remove the lower blade guard.
Do not put this guard in the trash, it is needed
whenever you want to transport the saw or use it as a
table saw.
To use it again as a table saw, proceed in reverse.
Publicidad
