Publicidad
Idiomas disponibles
Idiomas disponibles
1. Set the machine to miter saw mode;
2. Press the "ON/OFF" trigger on the saw handle.
As a miter saw, you must always press the trigger to
make the saw function.
To switch it off, release the trigger.
1. Set the machine to table saw mode;
2. Press the "I" button of the "ON/OFF" switch to turn on;
As a table saw, the motor runs without having to
press the switch continuously.
3. To switch it off, press switch button "0".
1. Loosen the miter locking handle (22) of the rotary
cutting table;
2. Press the lever and turn the cutting table to the left or
right according to the desired miter angle 45°- 0°- 45°;
The cutting table can rotate up to 45° on both sides
as shown in the scale.
3. The mitre angle indicator (21) indicates the angle
selected on the scale (20) placed on the support base.
1. Loosen the bevel angle locking lever to tilt the cutting
head left to desired bevel angle (0°- 45°);
2. The bevel angle indicator shows the selected angle on
the scale placed located at the rear of the machine.
1. Lift the cutting head over the workpiece, without cutting;
2. Press the swinging blade unlocking button (13);
3. Press the "ON/OFF" trigger (15) on the saw handle;
4. Press the cutting head down through the workpiece.
1. Set the machine to table saw mode;
2. The cutting table should be at an angle of 0°;
3. Place the miter gauge fence (6);
4. Press the "I" button on the "ON/OFF" switch (7) to switch
on;
5. Push the workpiece at a constant speed against the
blade guard.
Always use the push stick (3). Never use your hands
to move the workpiece.
Publicidad
