Disassembly, Cleaning And Care - Unold 48860 Instrucciones De Uso

18. Caution: Do not switch off the appli-
ance while it is making ice cream.
This would cause the ice cream
mixture to freeze to the edge of
the cooling container. If the motor
should overheat when ice cream
is being prepared, the motor swit-
ches off. In this case, place the
"EIN/AUS" ("ON/OFF") switch on
"EIN" ("OFF"), unplug the power
plug and allow the appliance to
cool. If you want to continue pre-
paring ice cream, it may be neces-
sary to use new ice cream ingre-
dients. In this case the ice cream
should be removed from the coo-
ling container with a plastic spa-
tula, not through the discharge
opening!
19. When the ice cream is ready,
place a suitable container under
the discharge valve.

DISASSEMBLY, CLEANING AND CARE

Before cleaning, always turn
off the appliance and unplug it
from the electrical outlet.
1. DO NOT clean the appliance, par-
ticularly the motor block under
water or a different liquid. Do not
use harsh or abrasive cleaning
agents.
2. The removable parts can be clea-
ned with warm water and a mild
washing-up liquid. The parts are
not dishwasher-safe.
3. To avoid injury/freezing, do not
touch the cooling container with
bare hands when you lift it out of
the appliance.
20. Slide the lever of the discharge
valve to „Open" and let the ice
flow into the container. Impor-
tant: Do not switch off the ice
cream machine when ice cream is
flowing out of the discharge valve!
There is a feed screw on the mixer
that conveys the ice cream down-
ward through the discharge valve.
21. When all the ice cream has been
removed, switch off the appliance
and unplug it from the electrical
outlet.
22. Tip: If the ice cream is too solid,
and cannot be removed via the
discharge valve, switch off the
appliance, unplug the power plug
and remove the ice cream from
the ice cream container with a
plastic spatula.
Motor
4. Unlock the lid and take lid, motor
and mixer off of the appliance.
5. Pull the mixer out of the motor.
6. Disconnect the motor from the lid.
To do this, you must press both
locking tabs, on the underside of
the lid/motor inward; this is the
only way to take off the motor.
7. Take the motor off of the lid.
8. Wipe off the motor with a damp
cloth, and then dry it thoroughly.
Lid
9. Wipe off the lid with a damp cloth,
and then dry it thoroughly.
29