Omnitronic CMP-3000 Manual Del Usuario página 32

All manuals and user guides at all-guides.com
Memorizing several samples:
With the CMP-3000, you can memorize up to 3 different samples of different tracks and recall them via the
Sampler-buttons.
Press the Memo-button (Memo-button lit) and the desired Sampler-button (Sampler-button flashes) in order
to memorize the current sample on the Sampler-button.
The memorized samples can be overwritten at any time. Please note that the samples can only be deleted
by switching the CD-player off an on again.
Playback of memorized samples:
Continuous-mode:
By pressing the respective Sampler-button, you can recall the memorized sample. The sample will be
repeated until you press the Sampler-button again.
The memorized samples can be played back at any time. If the Sampler-button is pressed during the
playback of the CD, the sample mixes with the CD-playback. If the Sampler-button is pressed in the Pause-
mode, the sample alone is being played back.
6.10 Relay-operation
In the Relay-operation, the device automatically switches to the other player after playback has stopped. In
this way, you have the possibility to enlarge the music program by using several CDs. In the Single-mode, on
track is played and then the CD is changed, in Continuous-mode, CD1 is completeley played and then CD2.
Press the Relay-button (LED on).
Start playback of CD1. As soon as the current track of CD1 is finished, the player automatically starts CD2.
The first CD-player goes into Pause-mode. You can enter a new CD or memorize a Cue-point at the
respective player in the Pause-Mode.
During the Relay-operation, the Faderstart-function is disabled.
You can switch the Relay-operation off via the Relay-button (LED off) and the Faderstart-function will work
again.
6.11 Faderstart
With the CMP-3000, you have the possibility to start the respective CD-player directly from the mixer. Make
sure that the Start/Pause-socket is connected with the respective socket on the mixer. Additionally, the Audio
Out-sockets have to be connected with the Line-input sockets of your mixer. Please note that the Faderstart-
function only works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode).
Start playback from your mixer.
Via the Remote Select-selector, you can choose between Tact and Lock.
Cue/Play
Please note that this selection is a Cue-point Faderstart-function. This means that the CD-player starts
playback after activating the respective channel of the mixer and goes into Pause-mode and returns to the
Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.
6.12 Effects
The different effects can be activated via the On/Off-button. If the effect is selected via the Select-button, the
respective LED is permanently lit.
The effect-parameters can be adjusted via the Scratch-wheel.
32/73 10602410_V_1_0.DOC