*1 The maximum total capacity of indoor units operating simultaneously is 150%.
*2 To enable the high static pressure setting, set the dipswitch on the main board as follows.
SW6-5: ON
SW6-4: ON
80 Pa
SW6-4: OFF
30 Pa
*3 When applying product below -20.0°C (-4.0°F), consult your design engineer for cold climate application best practices, including the use of a backup source for heating.
*4 Cooling mode
*5 The sound pressure level shown above indicates A-weighted sound pressure level. Although the sound pressure level in JIS has been changed to the sound power level (PWL), the value shown
above indicates the sound pressure level measured by the conventional method for reference purpose.