Mitsubishi Electric TRANE TURYP0723AN40AN Manual De Instalación página 27

9-7. Thermal insulation for pipes
Insulate pipes to prevent condensation.
- Condensation may collect and drip from the unit onto the ceiling or floor.
Insulate the high- and low-pressure pipes, and liquid and gas pipes separately with polyethylene foam insulation materials. Inadequate insulation
may cause condensation to drip. Pipes in the ceiling are especially vulnerable to condensation and require adequate insulation.
9-7-1. Insulation material
・Check that the insulation materials meet the standards in the table below.
Between an outdoor unit and BC controller
Thickness [mm (in)]
Heat resistance
Between a BC controller and indoor unit (R2 system)
Thickness [mm (in)]
Heat resistance
* The insulation thickness may need to be increased in high-temperature/humidity conditions.
* Even when specifications are defined by your client, the standards in the table should be met.
Ⓒ
Ⓑ
Ⓐ
Ⓓ
Ⓔ
Glass fiber + Steel wire
Insulation material
A
Adhesive + Heat-resistant polyethylene foam + Adhesive tape
Indoor
Outer covering B Under the floor and exposed
Outdoor
* If a polyethylene cover is used as an outer covering, asphalt roofing is not necessary.
・Do not insulate the electric wires.
Ⓑ
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Ⓔ
・Make sure that the pipe connections all the way from the indoor unit are properly insulated.
WT09115X03
High-pressure pipe
Min. 10 (7/16)
Min. 120°C (248°F)
Pipe size [mm (in)]
ø6.35 (ø1/4)–ø25.4 (ø1)
Min. 10 (7/16)
Min. 120°C (248°F)
Ⓐ Steel wire
Ⓑ Pipe
Oily mastic asphalt or asphalt
Ⓒ
Ⓓ Insulation material A
Ⓔ Outer covering B
Vinyl tape
Waterproof hemp cloth + Bronze asphalt
Waterproof hemp cloth + Zinc plate + Oily paint
Ⓐ High-pressure pipe or liquid pipe
Ⓔ
Ⓔ
Low-pressure pipe or gas pipe
Ⓑ
Ⓐ
Ⓒ Electric wire
Ⓓ Finishing tape
Ⓔ Insulation material
Ⓒ
Ⓓ
Low-pressure pipe
Min. 20 (13/16)
ø28.58 (ø1-1/8)–ø38.1 (ø1–1/2)
Min. 15 (5/8)
GB-25