Publicidad
Idiomas disponibles
Idiomas disponibles
1. SECURITY
THE OPERATION AND MAINTENANCE OF INVERTER WELDER EQUIPMENT CAN BE DANGEROUS AND
CAN AFFECT YOUR HEALTH
This equipment produces strong electrical and magnetic emissions that may interfere with proper
operation of pacemakers, hearing aids, and other electronic medical equipment.
Persons working near this equipment should consult a health professional to determine that so exposed
is it to risk.
To prevent possible injury, read, understand, and follow all warnings, safety precautions, and instructions
in this manual before using the equipment.
1.1. Description and explanation of signs
The Symbols located at the top, mean ATTENTION, Moving parts in operation. There is risk of electric
shock, or hot parts can damage parts and/or body. By following the Indications below, it is safe enough
to operate after taking the corresponding safety measures.
- The following signs and descriptions refer to the dangers and damages that your body or others may
su er when carrying out the cutting process.
- Remember when you see these symbols that cutting without proper protection can be dangerous.
- Only properly instructed and trained personnel can install, check, operate, maintain and repair any
SWEISS equipment.
- During operation, people not directly involved in the welding process should be far enough away,
especially children.
- After stopping the power of the equipment, to carry out maintenance or to examine the equipment,
proceed according to chapter "5", since residual voltage may remain in the capacitors and / or other
electronic parts.
1.2. Electric shock
- Never touch electrical parts.
- Use dry clothes and gloves with no holes for electrical isolation.
- Isolate yourself from work zone and ground with dry insulation. Make sure the isolation is large
enough to avoid physical contact with work area and ground.
- Take special measures when the machine is used on closed places, work at height or high humidity.
01
SWEISSWELD.COM
Publicidad
