cecotec BOLERO DRESSCODE 8300 INVERTER MAX A Manual De Instrucciones página 38

ESPAÑOL
Connection between the washing machine connector and the water supply hose.
- Align the curved part of the hose and the washer connector (inlet valve) on the back of the
product as shown in figure 7.
Tighten the compression nut by turning clockwise.
-
Connection between a screw tap and the water supply hose
- Screw tap and water supply hose.
- Align the other end of the water supply hose and the threaded tap and tighten the
compression nut tightly by turning clockwise. Check figure 8 for reference.
Drain hose.
Note
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
1. In a drainpipe. It is recommended to use a vertical tube. Fig. 9
2. In a sink's drainpipe, over the trap. Fig. 10
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
Acoustic sponges (depending on model)
Warning
Be sure to assemble the acoustic sponges, as they can reduce the noise caused by the washing
machine while it is running.
1. Place a soft material, such as foam or towels, between the base of the washing machine
and the floor for protection.
2. Gently lift the washing machine on one side and stick the longer sponges on the longer
bottom edges of the washing machine on its base. Do the same to adhere the shorter
sponges to the shorter bottom edges. Fig. 25
74
Bolero DressCode 8300_9300 Inverter Max A
4. OPERATION
Note
- Please make sure the appliance is properly installed before operation.
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
- All washing machines are thoroughly checked before leaving the factory and undergo
quality control. There may be a small amount of residual water in the drum. To remove it,
as well as to neutralise possible odours, it is recommended to clean the drum before the
first use. You can run a "Cotton" programme at 90°C without laundry and detergent.
Calibration
- It is advisable to calibrate the washing machine before its first use in order to get the best
performance from it.
- The device is able to detect the amount of laundry in the drum. Calibration optimises
product performance by minimising water and energy consumption.
- To perform the calibration, follow the steps below:
1. Remove any objects from the drum and close the door.
2. Plug the power cord into the outlet.
3. Switch on the machine and press the "Delayed Start" and "Temperature" buttons
simultaneously for about 10 seconds until the control panel displays "t19".
4. Next, to start the washing machine, press the Start/Pause button. The drum will start to
rotate slowly, and the display will show different numbers, when it shows a steady figure
the washing machine is calibrated, you can turn the device off.
Start of washing
Before washing. Fig. 11
1. Plug the appliance into a power supply.
2. Open the water supply tap.
3. Load the washing machine with the laundry.
4. Close the door.
5. Add detergent (and softener if necessary).
Note
- Detergent must be added in case I only after selecting pre-washing for machines with this
function.
- Make sure that the washing machine is properly installed before use.
Washing. Fig. 12
1. Turn the knob to select the desired programme.
2. Select function or use the default one.
3. Press Start.
ENGLISH
75
Bolero DressCode 8300_9300 Inverter Max A