cecotec BOLERO DRESSCODE 8300 INVERTER MAX A Manual De Instrucciones página 46

ENGLISH
4. Loosen the water supply hose from the rear part of the washing machine. Remove the filter
with a pair of fine-tipped clippers, taking care not to damage it.
5. Use a soft brush to clean the filter.
6. Return the filter to its original position and connect the hose.
7. Clean the filter every 3 months to guarantee optimum functioning.
Cleaning the detergent dispenser tank Fig. 23
1. Remove the detergent dispenser tank.
2. Press down the arrow on the softener cover inside the dispenser drawer.
3. Lift the clip up and take out the softener cover and wash all grooves with water.
4. Place the softener cover again and push it gently to introduce it in the detergent dispenser
in place.
Warning
- Do not use alcohol, solvents or chemical products to clean the detergent dispenser.
Clean the tank about every 3 months.
-
Cleaning the drain pump filter Fig. 24
Warning
- Be careful with the hot water!
- Allow any possible water remains to cool down.
- Unplug the machine to avoid electrical shock before washing.
The drain pump filter can filter the yarns and small foreign matters from the washing.
-
- Clean the filter periodically to ensure proper operation of the washing machine.
- Open the lower cover cap.
- Remove the filter by turning it counter clockwise.
Be careful, empty the water with a suitable container.
-
- Remove dust, dirt and other substances or objects.
- Place the filter again in its original position by turning it in the other sense.
- Open the lower cover cap.
Warning
- Make sure that the filter is reinstalled correctly.
- Rotate the lower cover cap (filter) so water runs directly into a suitable container.
When the appliance is in use and depending on the programme selected there can be hot
-
water in the pump. Do not remove the lower cover during the wash cycle, always wait until
the appliance has finished the cycle and is empty.
- When replacing the cover, ensure it is securely re-tightened.
90
Bolero DressCode 8300_9300 Inverter Max A
6. TROUBLESHOOTING
Problem Cause
The washing machine does The door is not closed
not turn on properly. It is not connected
to a power outlet
The door does not open The safety lock system is
activated
Water leakage Bad connection between
pipes and water supply hose
or drainpipe.
Detergent residues in the box Detergent is dampened or
agglomerated
Indicator or display does not The PCB is disconnected, or
light the system connector has
connection problems
Abnormal noise.
Errors
Error Cause
E30 The door is not closed
properly
ENGLISH
Solution
Restart after the door is
closed.
Check if there are clothes
stuck.
Plug it to a mains socket.
Check that the control and
protection elements of the
electrical installation are
activated.
Unplug it and restart the
product.
Check and fasten the water
pipes and hoses correctly.
Clean the hoses ensuring they
are not blocked.
Clean and wipe the detergent
box
Check for power supply.
If the problem persists,
contact the official Technical
Support Service of Cecotec.
Check if the fixing bolts have
been removed.
Make sure the appliance is
installed on a solid, level
floor.
Level the washing machine
adjusting its feet.
Solution
Restart after the door is
closed.
Check if there is laundry or
dirt stuck.
91
Bolero DressCode 8300_9300 Inverter Max A