cecotec BOLERO DRESSCODE 8300 INVERTER MAX A Manual De Instrucciones página 44

ENGLISH
Bulky/Bedlinen 40 1000
Rinse&Spin - 1000
Drum Clean 90 -
Please note:
- The table shows the cycles' options and how they can be adjusted.
It also shows if some settings are not compatible with some cycles.
-
Selectable options
Fig. 20
A. Display
B. Child Lock icon
C. Door Lock icon
D. Delay Start icon
E. Temperature icons (Temp)
F. PreWash icons (Prewash)
G. Extra Rinse icon (Extra Rinse)
OPTIONS
Delay Start
- To set the Delay start function:
1. Select a programme.
2. Press the Delay button to choose the time (the delaying time is 0-24 H.).
3. Press Start/Pause to activate the delay operation.
- To cancel the "Delayed Start" function, press the button before starting the programme
until the display shows 0H. If the programme has already started, switch the device off and
on again and select a new programme.
Extra rinse
1. Select a programme.
2. Press "Function" button and select "Extra Rinse" to make the machine perform an extra
final rinse ("Extra Rinse" icon will light up).
Spin speed
1. Select a programme.
2. Press this "Speed" button to select the desired speed, following the next cycle per press:
- 1200: 0-400-600-800-1000-1200
- 1400: 0-400-600-800-1000-1200-1400
86
Bolero DressCode 8300_9300 Inverter Max A
1000 Extra rinse and
delayed start.
1000 Delay Start
- Delayed Start/
Prewash/Extra Rinse
Pre-Wash
1. Select a programme.
2. Press "Function" button and select "Prewash" to make the appliance perform an additional
wash before the main wash cycle starts, to increase the washing performance ("Prewash"
icon will light up).
Note: detergent must be added to compartment I.
Cleaning the drum
- After the machine runs a preset period of wash cycles, the Drum Clean light will flash at
the end of the last programme, reminding you to run the programme as follows:
1. Empty the drum and close the door.
2. Press "Drum Clean".
3. Press "Start/Pause".
- The number of wash cycles will count back from 0 when the drum cleaning programme is
finished.
- If you want to remove the drum cleaning warning:
- Press and hold the "Drum Clean" button for about 3 seconds, the warning will be cancelled,
and the wash cycles will restart counting from 0.
Temperature (6)
When necessary, the wash temperature can be adjusted by pressing the button and following
the sequence below: Cold-20ºC-40ºC-60ºC-90ºC.
Mute Mode
1. Select a programme.
2. Press and hold the Speed button for approx. 3 seconds. No beeps shall be heard.
3. To reactivate the sound, press the Speed button again for about 3 seconds.
Note: the setting will be saved until next restart.
Child Lock function
Press the Temp and Function buttons at the same time for about 3 seconds.
-
Please note.
- When the child lock is activated and the washing programme starts, the display will
alternately show "CL" and the remaining time of the washing cycle.
Pressing any button will cause the indicator to flash.
-
- When the wash cycle is finished, "Cl" and "END" alternate on the display.
- Press and hold the two buttons Temp and Function to unlock the function.
- This function locks all buttons except the Start/Pause button and the child lock button
itself.
- Deactivate the child lock function before selecting a programme and starting washing.
ENGLISH
87
Bolero DressCode 8300_9300 Inverter Max A