Grouw 18070 Manual De Instrucciones página 45

Assembly
Fitting the handle
Screw the bottom part of the handlebar (7)
securely to the lawnmower using 2 bolts, 2
washers and 2 cap nuts on each side.
Loosen the grips (5). Unfold the upper part
of the handlebar (4) and secure it by tilting
the grips (5) in towards the handlebar. If
necessary, tighten the grips' lock nuts on the
inside of the handlebar using a spanner.
Secure the cable clips (6) to the handlebar to
hold the cables in place.
Securing the starter handle to the
handlebar
Press the safety control handle (2) in towards
the handlebar (1) and pull the starter handle
(16) slowly out.
Insert the starter handle cord into the eye on
the handlebar.
GB
45