Publicidad
Idiomas disponibles
Idiomas disponibles
PEAK TIME t
p
TIG DC:0,01 ÷ 0,99 sec
TIG AC:0,10 ÷ 0,99 sec
BASIC TIME t
b
TIG DC:0,01 ÷ 0,99 sec
TIG AC:0,10 ÷ 0,99 sec
NOTE: setting the value of a parameter (usually
I
) while EASY PULSE is working, will give the
p
values of the other parameters (I
Keep pressing the SET key for about 1 second to
leave the weld parameter setting phase
4) TIG-weld as desired
NOTE: The RED Ip and GREEN I
on continuously during the weld process and the
display will visualize the current value used for
welding
TIG PULSATING WELDING WITH CYCLE FUNCTION ON
Two different levels of pulsating current (I
for welding with this function. Here also welding can be done
in the two ways ON PULSE and EASY PULSE.
It is also necessary to set the 2
(apart from the pulsating parameters Ib, Ip, f) with the CYCLE
nd
function on. The other 2
CURRENT I
and FREQUENCY f) are obtained in synergy.
2b
FREQUENCY remains constant while the 2
CURRENT (I
) is in proportion to the ratio between the 1
2b
level currents.
ON PULSE AND EASY PULSE METHODS
1) Start up the welder by turning the main switch to position I
2) Press the "weld mode" button and set on
CYCLE
Fast ON-PULSE (only TIG DC)
3A)Press the "pulsation" button until the desired
function is working (the ON PULSE LIGHT is
on)
, f) in synergy
b
leds will stay
1
and I
) can be used
1
2
nd
level PEAK CURRENT (I2p)
level pulsating parameters (BASIC
nd
level BASIC
4A)Press the SET key until the GREEN led I
the RED led I
level PEAK CURRENT I
by turning the special dial.
5A)Press the SET key until the RED led of the 2
level of PEAK CURRENT I
flashing
• Adjust the parameter by turning the special dial
6A)Press the SET key until the RED led of the 1
level BASIC CURRENT (5 ÷ 250 A) starts
flashing
st
• Adjust the parameter by turning the special dial
7A)Press the SET key until the RED led of the
PULSATION FREQUENCY (0.5 ÷ 500 Hz)
starts flashing
23
will start flashing; adjust the 1
p
(5 ÷ 250 A); value
1p
(5 ÷ 250 A) starts
2p
and
1
st
nd
st
Publicidad
