Create WINECOOLER XXL Manual Del Usuario página 8

BEFORE USING YOUR WINE COOLER
• Remove the exterior and interior packing.
• Before connecting the wine cooler to the power source, let it stand upright for approxi-
mately 4 hours. This will reduce the possibility of a malfunction in the cooling system from
improper handling during transportation. Clean the interior surface with lukewarm water
using a soft cloth.
INSTALLING YOUR WINE COOLER
• This wine cooler is designed to be free standing only, and should not be recessed or built-in.
• Allow 5 inches of space between the back and sides of the wine cooler, which allows the
proper air ventilation. Adjust the feet to keep the wine cooler level. Locate the wine cooler
away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Am-
bient temperature below 5°C or above 32°C will hinder the performance of this appliance.
• Depending on the location of the appliance, the direction of the door opens can be changed.
• This unit is not designed for use in a garage or any other outside installation.
• Avoid locating the wine cooler in moist areas.
• Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any ques-
tions concerning power and/or grounding should be directed toward a certified electrician
or an authorized service center.
• This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool
down for 3 ~ 4 hours under before placing wine bottles or beverages in the appliance.
C O NTROL PAN E L
SELECT THE TEMPERATURE
• The unit has two temperature zones. For each zone,the temperature range can be set
between 5 °C and 18 °C (40 °F and 65 °F).
IMPORTANT:
• The temperature selected for the lower compartment must always be higher than the top
compartment. For optimum performance, the difference between the two zones should
be maximum of 6 °C to avoid damage related to condensation.
THE WINE COOLER SHELVES
• The shelves are fully adjustable to suit various wine bottle shapes and sizes.
• To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out
of the rail compartment.
• For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves
are designed with an emergency stop to prevent them being removed too far when loaded.
E NGL I SH
8
INSTALLATION INSTRUCTIONS
OPERATING YOUR APPLIANCE