Create WINECOOLER XXL Manual Del Usuario página 9

BEFORE SWITCHING ON
• Make sure that it has been installed by a suitably qualified person, as per the information
contained in the installation instructions.
• After delivery, wait for four hours before connecting the appliance to your mains supply.
This will allow any refrigerant gasses that may have been disturbed during the transpor-
tation process to settle.
• The outside of the appliance and the removable accessories contained within it, should
be cleaned with a solution of liquid detergent and water.
• The interior of the appliance should be cleaned with a solution of sodium bicarbonate dis-
solved in lukewarm water.
• The interior and accessories should be thoroughly dried, after the cleaning process has
been completed.
• There can be an odour when you first switch on the appliance. It will lessen as the appli-
ance starts to cool.
DURING FIRST USE
Important: When you use the wine cooler for the first time or restart the appliance after
it has been turned off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED display. This is normal and it is
due to the length of activation time. Once the wine cooler has been running for a few hours
everything will be back to normal.
• When you first switch on the appliance, the compressor will run continuously until the
wine cooler reaches a cool enough temperature.
• During this period of time, you should try not to open the door frequently or place bottles
inside of the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before restart-
ing the appliance or reconnecting it to your mains supply.
SWITCHING ON THE APPLIANCE AND SETTING THE TEMPERATURE
• Switching between Celsius and Fahrenheit: To alter what the temperature displays are
showing, press the light button for 5 seconds.
• Switch on/turn off: To switch on the wine cooler, press the light and temperature buttons
and hold 5 seconds. To turn off the appliance, press and hold the light and temperature
buttons and hold 5 seconds.
• Temperature Setting: Press the temperature button to set the internal temperature of
each zone. Temperatures in degrees will appear on every screen corresponding to dis-
tinct area for the top and the lower compartment.
• Note: When the temperature button is pressed for the first time, the LED displays indi-
cates the factory preset temperature, 10 °C/50 °F for the upper and 16 °C/60 °F for the
lower compartment.
• Press the temperature button once. The display for the upper compartment will flash.
Press up and down buttons to increase/decrease the temperature.
• If you press again the temeperature button, the display for the lower compartment will
flash. Press up and down buttons to increase/decrease the temperature.
• When working with both upper and lower zone, setting temperature of upper zone must
be lower than the lower zone as factory default setting.
INTERIOR LIGHT
• The cooler has an interior light. The light can be switched on and off by using the light
button.
Note: To see the temperature of each zone at any time. Touch the up and down buttons, set
temperature temporarily flash on the display for about 5 seconds. Use the "SET" to see the
selected temperature zone or the other.
HOW TO USE YOUR WINE COOLER
E NGLI SH
9