cecotec Cumbia CREMMAET COMPACT Manual De Instrucciones página 23

ENGLISH
7. Decalcification
When " " lights up, it means that the coffee machine needs to be descaled.
8. Warning of water shortage in the internal pipeline
When " " lights up on the control panel, it means that there is a shortage of water in
the internal piping of the coffee machine. Make sure that there is water in the tank and that it
is properly installed. Press the " " button to restart the pump and expel the accumulated
air, causing the water to flow through the internal piping.
5. CLEANING AND MAINTENANCE
Daily maintenance
Daily maintenance is important to extend the life of the coffee machine and to obtain better
results.
Components Maintenance
Remove the brewing unit
and wash it under running
water, then remove the coffee
residues. Clean the processing
Brewing unit unit by hand every 3 days.
Do not wipe lubricating oil
from the bottom and centre
of the processing unit. Do not
wash it in the dishwasher.
Remove the drip tray and the
waste container, rinse them
Drip tray
under running water and wipe
and waste
them with a cloth.
container
Clean them at least every two
days.
Rinse the tank under running
water every 3 days.
Water tank
Empty it if you are not going to
use it for a long time.
44 CREMMAET COMPACT
Other models
To clean the brewing unit, you can use a
coffee machine cleaning tablet: remove the
brewing unit, place a cleaning tablet inside,
place it back into the coffee machine and
brew an Espresso with the maximum
amount of coffee.
Then remove the processing unit again and
clean the product residues by hand.
Clean the coffee bean
container weekly. Use a soft,
dry cloth to wipe oil/coffee
grounds from the inside.
Coffee bean If there is too much oil inside
container/ the bean container, it is
grinder possible that there is too much
oil in the grinder.
Clean the grinder thoroughly in
case of grinding problems.
Open the right panel, remove
the brewing unit and clean the
Ground coffee
ground coffee channel with a
groove
soft cloth on a weekly basis.
Dismantling parts for cleaning
Fig. 15
1. Pull the water tank upwards and remove it.
2. Pull the right panel outwards.
3. Press where the blue arrow in figure 15 indicates and remove the processing unit.
4. Lift the drip tray slightly and remove it.
Fig. 16
1. Replace the water tank in the coffee machine.
2. Push the processing unit along the groove until a snapping noise is heard, as shown in
figure 16.
3. Push the drip tray inwards into place.
Warning:
- When reinstalling the processor unit, a snapping noise will be heard; if you do not hear it,
disassemble the processor unit again and reinsert it.
- Make sure that the water tank is fully inserted. If this is not the case, push the water tank
down until it clicks into place.
6. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If a mechanical failure occurs in the appliance, please contact your supplier, authorised dealer
for repair or the official Cecotec Service Centre.
ENGLISH
To clean the bean container and the
grinder, you can use a grinder cleaner for
coffee machines: place the cleaner inside
the container and prepare an espresso
with the maximum amount of coffee.
Then, clean the container by hand.
CREMMAET COMPACT 45