KRESS MISSION KR233 Instrucciones De Usuario página 12

Maintenance
Your Mission RTK
TM
require replacement as they become worn. Never use your Mission
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your Mission
1
Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your Mission
and put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
turning disc. Failure to use new screws could cause serious injury.
The Mission RTK
TM
mowers. Its cutting blades are razor sharp on 2 edges
and rotate in both directions for maximum cutting
capacity. Redesigned blade profile better prevents grass
clippings from getting caught in the gap between the
disc and the blade. And with new material, the service
life of each cutting blade will be longer than that of
other brands' when it is programmed to mow every
day. Always check to see if the blades are chipped or
12
damaged and replace them if they are. When the cutting
EN
blades are dull and worn out, they should be replaced
with the spare blades provided with your Mission
RTK . Spare blades are also available at your nearest
n
Kress retailer.
A. Replace the blades
Usually your Mission
replaced every week, you can adjust the frequency
of replacing the blade according to the cutting quality
of the lawn. When replacing the blades, make sure to
replace all of them at the same time. You can replace
them with one of the spare blade kits and extra blade
screws supplied with your Mission
Before attempting to replace your Mission
blades, turn the power off and put on protective gloves
and follow these steps:
1. Gently flip the Mission
2. Remove the battery cover and remove the battery.
3. Take the 3 screws for fixing disk from each disk off
seperately with a hexagon screwdriver.
4. Remove the two disks.
5. Take the 6 screws for fixing blades off with a
works hard and needs to be cleaned and checked from time to time. Some parts will
n
TM
does not cut grass like other
n
RTK 's blades need to be
TM n
RTK .
TM n
TM
RTK over.
TM n
RTK .
n
TM
RTK 's
n
RTK with defective on/off switch.
TM n
1
2
RTK OFF
TM n