Publicidad
Idiomas disponibles
Idiomas disponibles
4. After processing, and once the appliance has completely stopped, remove the lid by
rotating it counter-clockwise, remove the disc and empty the contents, eliminating any
food residue using a spatula.
If food builds up around the blades during use:
1. Release the speed button and wait for the blades to completely stop.
2. Remove the processing lid.
3. Use a spatula to carefully remove the food. Do not use your fingers because the blades are
sharp!
4. Once the food has been removed and the blades cleaned, refit the lid and continue processing.
Notes and tips:
•
Most processing takes less than 6 seconds, therefore, exercise caution during processing
to avoid unwanted results.
•
Do not use the appliance for more than 1 minute continuously. After 1 minutes of
continuous use, the unit may overheat. Wait 5 minutes before using the unit again.
3 cycles, the appliance must be stopped for 15 minutes to allow the main motor to cool
down.
•
Do not shake or move the appliance during processing.
•
Start processing with pulse movements, rapidly pressing and releasing the speed button
until obtaining the desired consistency.
•
Do not use to chop very hard dry foods such as meat with bones, soybeans, pepper,
coffee beans, ice cubes and frozen food.
•
Do not overload the appliance motor; it is better to add the ingredients gradually through
the special filler
•
Do not process hot ingredients. Leave hot ingredients to cool down to room temperature
before placing them in the bowl.
•
For the food blender and grater disc, it is recommended to cut the ingredients into 2 cm
pieces before inserting them in the
•
To avoid damaging the blades, the first 3 seconds of the "Chop hacher" button will be at
maximum speed, then be reduced.
•
The food blender can prepare up to 45 x 300g sauté mixes in a single charge cycle.
INDICATOR LIGHTS
The indicator lights of the immersion blender provide information about different situations.
•
Battery duration during use:
When the food blender is used and the battery starts to discharge, the LED lights turn off
from top to bottom, indicating the residual battery charge.
-
From 100% to 66% charge: lights 1, 2 and 3 will all be lit
-
From 65% to 33% charge: lights 1 and 2 will be lit
-
From 32% to 20% charge: light 1 will be lit
-
If the battery has less than 20% charge, light 1 will flash and the appliance needs to be
charged.
•
Charge indication:
The indicator lights also provide feedback during the charge process:
-
If the battery charge is less than 33%, lights 1, 2 and 3 flash during charging.
-
If the battery charge is between 65% and 33%, light 1 will be steadily lit, and lights 2 and
3 will flash.
-
If the battery charge is between 99% and 66%, lights 1 and 2 will be steadily lit and only
light 3 will flash.
-
If the battery charge is greater than 99%, lights 1, 2 and 3 will be steadily lit and the
tube.
bowl.
After
24
Publicidad
