GreenWorks Commercial CZ48R18X Manual Del Operador página 18

rough, uneven terrain. After setting the cutting height,
adjust the anti-scalp wheels so they extend below the
deck but do not contact the ground. They should always
be at least 1/4" to 3/4" (0.6cm to 1.9cm) below the deck.
With the unit sitting on a flat level surface, the wheel
position can be adjusted up or down as needed from
3/4" to 1-3/4" (1.9cm to 4.4cm) below the blade surface.
Move the wheels up or down - using the different axle
mount holes in the wheel mount bracket (if applicable
on model).
9.6 ELECTRIC TAKE OFF (ETO)
SOCKET FOR CONNECTING
ACCESSORIES
The machine can be used together with other
attachments such as the blower.
10 OPERATION
10.1 BEFORE OPERATION
10.1.1 ADJUST THE SEAT
WARNING
Make sure seat pan is securely bolted down prior to
each use to prevent seat from moving/tilting in the
event of mower tipping or rollover.
The seat can be adjusted forward and rearward by
moving the latch (1) under the seat. Move the latch
outward and pull the seat where you have the best
control of the machine and are the most comfortable
and then tighten the safety belt.
You can adjust the suspended preussre of the seat
by turning the cyclone float knob (2). Turn clockwise
the preload will increase and counterclockwise for the
preload to reduce.
English
1
17
10.1.2 ADJUST THE STEERING CONTROL
LEVER
The steering control levers can be adjusted for operator
comfort. By loosening the cap screws (1) that attaches
the upper control lever (2) to the lower lever (3), the
upper control lever can be pivoted to fit the operator's
personal preference. The steering control levers should
be adjusted so that they align with each other when in
the neutral position.
2
3
1
10.1.3 ADJUST THE DECK CUTTING HEIGHT
Before using the mower, raise the deck height to the
cutting position best suited for your lawn.
Deck height is adjustable from 1"-5". Deck should be
raised while mowing is in progress to avoid stumps,
rocks or other obstacle that can be damage mower
deck.
EN
1
2