Publicidad
Idiomas disponibles
Idiomas disponibles
•
During normal mowing, cut only about 1/3 of the grass blade. Cutting more than that is not recommended
unless grass is sparse or it is the end of the mowing season.
•
Alternate mowing pattern between cuts to keep the grass growing straight and better dispersion of the
clippings.
•
Remember, grass grows at different rates at different time of the year. Mow more often in the early spring to
maintain the same cutting height. As the growth rate slows in mid summer, mow less frequently. If you cannot
mow at a regular interval, mow at a high cutting height at first, then mow again two days later at a lower cutting
height.
•
Raise the cutting height of the mower if the cutting width of the mower is wider than the previous mower. This
ensures that uneven turf is not cut too short.
•
Raise the cutting height of the mower if the grass if slightly taller than normal or if it contains a high degree of
moisture. Then mow it again with the cutting height set lower.
•
If the machine's forward motion must be stopped while mowing, a clump of grass clippings may drop onto
your lawn. To avoid this, move onto a previously cut area with the blades engaged.
•
Charge the battery immediately.
Model No.
Battery capacity
CZ60R24X /
CZ52R24X /
CZ48R24X /
5%-10%
CZ60R18X /
CZ52R18X/
CZ48R18X
•
Allow motors 30 minutes to cool down. If drive motor exceeds programmed temperature, the motor speed will
decrease. If temperature continues to increase, drive will shut down at a higher programmed temperature.
12
ELECTRICAL SYSTEM
12.1 ELECTRICAL SYSTEM SAFETY
•
Remove the key fob, disconnect battery cables
(P+) in battery box compartment and read operator
manual before adjusting or repairing unit.
•
Always remove the key fob, and disconnect battery
cables (P+) in battery box compartment before
working on this unit.
•
Always disconnect battery cables (P+) in battery box
compartment when transporting unit.
•
Keep unit free of grass clippings, leaves and other
debris. DO NOT spray water to clean unit. Use only
compressed air. Wear adequate eye and hearing
protection when cleaning the unit.
•
Always wear safety glasses and protective gear
near battery. Use insulated tools.
•
Clean battery compartment, drive motor
compartment, mower deck, etc., of all dirt and
debris. Do not use solvents, hard cleaners or
abrasives.
•
With the mower is ON, mower blade can engage
when deck blades ON/OFF switch (PTO) is
engaged, even if drive motor is not turning. Keep
area clear of bystanders when engaging deck
blades ON/OFF switch (PTO).
•
Never allow flames, sparks or smoking near
batteries.
•
Keep batteries out of reach of children.
English
Action
The maximum drive
speed will be 5.5 mph
and the unit will in low
blade mode.
•
Always keep protective shields, covers and guards
in place and securely fastened. If they become
damaged, repair or replace immediately. Never
modify or remove safety devices.
12.2 ELECTRICAL SYSTEM
INFORMATION
The greenworkscommercial mower is powered by an
82-volt electrical system. It consists of the following
components:
1. Blade controller (1)
2. Blade motor (3)
3. Drive controller (2)
4. Accelerator - right (1)
5. Accelerator - left (1)
6. Digital display (1)
7. Wheel motor with PGR (Planetary Gear Reduction)
(2)
8. Battery pack (1)
9. PBS switch (Push button start switch) (1)
10. PTO switch (Deck blades ON/OFF switch) (1)
11. Headlight (1)
12. Sidelight - right (1)
13. Sidelight - left (1)
14. Taillight (1)
15. Overhead light (1)
21
Battery capacity
Action
The working blade will
stop automatically. The
unit should immediately
<5%
be returned to the bat-
tery charging area and
the unit connected to the
battery charger.
EN
Publicidad
