Descargar Imprimir esta página

GreenWorks Commercial CZ48R18X Manual Del Operador página 55

Cortadora de césped de radio de giro cero

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
5. Disconnect battery cables (P+) in battery box
compartment.
6. Lift the front of the mower and block and secure the
machine to allow serviceman to change the blade
under the mower.
7. While wearing leather padded gloves, grasp the
blade closely with one hand in order to prevent the
blade from turning and use a 24mm wrench with
your other hand to loosen the bolt fixing its blade in
place.
8. Turn the bolt COUNTERCLOCKWISE to loosen and
CLOCKWISE to tighten.
9. Remove the bolt and the blade.
P+
English
15.1.2 INSTALL THE BLADE
1. Place the blade with the cutting blade toward the
ground.
2. Install the bolt.
3. Turn the blade nut CLOCKWISE with a socket or
wrench to secure the blade.
15.2 TIRES
It is important for level mowing that all tires have
the correct amount of air pressure. The recommended
pressure are:
Tire pressure should only be measured or adjusted
when tires are cold.
Front caster wheels
Drive wheels
Inspect the tires daily. Replace immediately if
damaged.
Check the tire pressure carefully while inflating. Too
much air in the tire could cause the tire to burst,
causing serious personal injury.
15.3 TORQUE VALUES
Particular attention must be given to tightening the
drive wheel lug nuts and blade spindle bolts. Failure to
correctly torque these items may result in the loss of
a wheel or blade, which can cause serious damage or
personal injury.
Torque values are given below:
Part
Wheel (lug) nuts 70-77
54
NOTE
28 psi
20 psi
NOTE
WARNING
WARNING
Ft-lbs.
Nm
90-105

Publicidad

loading