cecotec BOLERO SQUAD I 3001 Manual De Instrucciones página 61

- The wall and the area over the work surface must be heat resistant.
- To avoid any damage, the bonding layer and the adhesive must be heat resistant.
Connecting the hob to the mains
Fig. 9
The induction hob must be connected to the mains by a suitably qualified person.
Before connecting the hob to the mains, check that:
1. Your home wiring system is suitable for the power consumption of the cooking hob.
2. The mains voltage matches the voltage stated on the rating label of the appliance.
3. The power cable sections can withstand the load specified on the product rating label.
- To connect the induction hob to the mains, do not use adapters, reducers or branching
devices, as they may cause overheating or fire.
- The power cord should not be in contact with any hot parts and must be positioned to
avoid its temperature exceeding 75°C.
Warning
- Check with an electrician whether your home wiring system is suitable without modifying
it.
Any modifications should only be carried out by a qualified electrician. Fig. 9
Legend Fig. 9:
1. Yellow/green earth wire
2. Phase 1 (L1) black wire
3. Phase 2 (L2) brown wire
4. Neutral (N1) blue wire
5. Neutral (N2) blue wire
It can be connected directly to the mains by means of a single-phase electrical connection, as
shown in fig. 10.
Legend Fig. 10
1. Yellow/green earth wire
2. Phase 1 (L1) black wire
3. Phase 2 (L2) brown wire
4. Neutral (N1) blue wire
5. Neutral (N2) blue wire
- If the cord of the induction hob is damaged, it must be replaced by the manufacturer, the
supplier, or similarly qualified personnel to avoid a hazard.
- If the appliance is connected directly to the mains, a single-pole residual current circuit
breaker with a minimum contact separation of 3 mm must be installed.
ENGLISH
BOLERO SQUAD I 3001
61