Publicidad
Idiomas disponibles
Idiomas disponibles
Operation instructions
Install and replace batteries
Install 2 pieces of 7# alkaline batteries.
•
•
Slide the cover to install batteries and make sure to place
them in right pole.
AUTO operation
Switch on the power and running indicator light on indoor unit
flashes.
1-
Press MODE to select AUTO.
2-
Adjust temp via
and
. Generally the range is 17~30ºC.
3-
Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on AUTO mode and fan
speed is AUTO which is nonadjustable.
4-
ECO is effective on AUTO operation.
COOL/HEAT/FAN operation
1-
Press MODE to select COOL, HEAT or FAN.
2-
Adjust temp via
and
. Generally the range is 17~30ºC.
3-
Press FAN SPEED to select AUTO, LOW, MED or HIGH.
4-
Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on the set mode. Stop
operation via ON/OFF.
Note:
On FAN mode, temp is nonadjustable and ECO is
ineffective. Procedure 2 is omitted.
DRY operation
1-
Press MODE to select DRY..
2-
Adjust temp via
and
. Generally the range is 17~30ºC.
3-
Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on DRY mode. Turn off
the unit via ON/OFF.
4-
On DRY mode, ECO and FAN SPEED are unavailable.
Timer operation
TIME ON and TIME OFF are used to turn on and turn off the
unit at the set time respectively.
TIME ON operation
1-
Press TIME ON, icon SET, HOUR and ON are lightened.
2-
Press TIME ON again and adjust the time.
3-
Keep pressing this button, the time will increase by 0.5
hour. When the set time exceeds 10 hours, pressing the
button will increase the time by 1 hour.
4-
0.5s after setting, remote controller will send TIME ON
command to the unit.
TIME OFF operation
1-
Press TIME OFF, icon SET, HOUR and OFF are lightened.
2-
Press TIME OFF again and adjust the time.
3-
Keep pressing this button, the time will increase by 0.5
hour. When the set time exceeds 10 hours, pressing the
button will increase the time by 1 hour.
REMOTE CONTROLLER
4-
1-
2-
3-
10 hours, time OFF operation will activated 0.5 hour later than
4-
Press corresponding button and readjust the time of time
ON and time OFF. Adjust the time figure to 0.00 to cancel the
timer operation.
Note:
based on the clock on remote controller. Adjusting clock is
unavailable when TIME ON or TIME OFF is activated.
0.5s after setting, remote controller will send TIME OFF
command to the unit.
Set TIME ON and TIME OFF simultaneously
Set TIME ON according to procedures 1 and 2 specified in
TIME ON operation..
Set TIME OFF as the procedures 1 and 2 specified in OFF
operation..
If both the set time of TIME ON and TIME OFF not exceed
time ON operation. If both the set time of TIME ON and
TIME OFF exceed 10 hours, time OFF operation will be
activated 1 hour later than time ON operation.
0.5s after setting, remote controller will send TIME ON
command to the unit.
Modification of timer operation
The time set in timer operation is the relative figure
39
Publicidad
