Publicidad
Idiomas disponibles
Idiomas disponibles
EN
English
IT
Italiano
FR
Français
water spilling out during boiling.
3. Close the lid.
DE
Deutsch
4. Place the kettle on the base and make sure that it is attached securely.
5. Connect the power base plug to the power socket; the appliance will beep and "---" will flash
ES
Español
on the display. The appliance will turn off automatically if no button is pressed within 30
seconds.
6. Point the kettle spout away from furniture, walls, etc. to prevent the steam from causing any damage.
7. Press the
of 100°C and the
temperature from 38°C to 100°C (100°F – 212°F). The appliance beeps twice after a few
seconds to indicate that the heating cycle has started. During this process, the display will
show the actual water temperature. When the water reaches the temperature selected
previously, the appliance will beep 3 times and the kettle will turn off. The display will show the
actual water temperature for about 5 minutes before turning off. To switch the kettle off at any
time, press the
IMPORTANT:
• If the kettle is removed from the base before the boiling cycle has finished, "E1" will appear on
the display, the appliance will beep 3 times and turn off automatically.
• To switch off the kettle before the boiling cycle has finished, press the
• To ensure that the kettle works efficiently, it is advisable to filter no more than 5 litres per day (taking
care to wait a few minutes between one filtration cycle and the next). Replace the filter cartridge
every 150 litres/30 days of filtration (this will ensure maximum appliance efficiency and safety).
DO NOT open the lid when the kettle is hot.
If you want to use the kettle again, let the safety cut-out cool down for 60
seconds, then press the
If the kettle is switched on by mistake when it is empty, the thermostat
automatically performs an on off cycle to prevent the kettle from overheating.
If this happens, "E4" will appear on the display; press the
immediately disconnect the kettle. Let the kettle cool down before refilling it.
8. After use, return the kettle to its base or put it on a heat-resistant surface.
9. Disconnect the power cable from the power socket when not in use.
HOW TO HOLD THE WATER AT A CONSTANT TEMPERATURE
After the boiling cycle, the filter kettle can hold the water at a set temperature for up to 2 hours.
1. With the appliance on, turn the dial to select the hold temperature for the filtered water (38°C
to 100°C/100°F–212°F).
2. Press the
the display. The time can be reduced or increased up to 2 hours by turning the dial. If the
temperature of the water in the kettle is lower than the selected temperature, the kettle
automatically heats it, then beeps and holds it constant. The set time will count down on the
appliance display.
If the temperature of the water in the kettle is higher than the selected temperature, the set
English
Italiano
Français
Deutsch
Español
button on the base; the appliance will beep and the pre-set temperature
symbol will appear on the display. Turning the dial sets the heating
button.
button.
button; the
symbol and the pre-set time of 30 minutes will appear on
EN
IT
FR
DE
ES
22
button.
button and
Publicidad
