Foppapedretti Street Manual De Instrucciones página 38

• ENGLISH •
USE IN THE VEHICLE
USING THE BUCKLE
To attach the buckle: Hold together the central buckle tabs and insert them in the
special slot inside the harness buckle. A "click" will indicate that it has attached
correctly (fig. 3).
To release the buckle: Press the red button to remove the tabs from the central buckle
(fig. 4).
HEADREST ADJUSTMENT
The headrest can be adjusted to different heights. Pull the handle of the adjustment
and raise or lower the headrest to the correct position (fig. 5).
In group 76-105cm, the adjustment of the headrest also changes the height of the
shoulder straps.
HOW TO INSTALL THE ISOFIX SYSTEM
If your car does not have standard ISOFIX connector guides, insert those supplied with
the car seat with the recess facing upwards in the two ISOFIX anchoring points in the
car (fig. 6, 7).
☞ SUGGESTION: The ISOFIX anchoring points are located between the seat and the
backrest of the passenger seat.
Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click". The indicator on both brackets will turn green,
confirming that they have attached. Check that both brackets are correctly fastened
Shake the car seat to be sure it is correctly fixed in place (fig. 8).
Push the car seat against the passengerseat, making sure that both ISOFIX connectors
are extended in the same position (fig. 9).
Mode A - INSTALLATION IN THE FORWARD-FACING POSITION
(Children between 76 and 105 cm in height, ISOFIX + Top Tether + harness)
Installation only on vehicles equipped with an ISOFIX anchoring system and Top Tether
attachment.
WARNING! Using the car seat in the rear-facing position is mandatory for a child up to
15 months of age and 76 cm in height.
Press both sides of the adjustment/release button on the ISOFIX connectors
simultaneously and extend the ISOFIX connectors (fig. 10).
Locate the ISOFIX attachments supplied with the vehicle (fig. 11).
If your car does not have standard ISOFIX connector guides, insert those supplied with
the car seat, see paragraph "How to install the ISOFIX system".
Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click". The indicator on both brackets will turn green,
confirming that they have attached. Ensure that both brackets are correctly fastened.
Push the car seat against the passenger seat, making sure that both ISOFIX connectors
38