RHOSS TCAEY-THAEY 115 P1 Instrucciones De Uso página 26

II.4 TRANSPORT - HANDLING - STORAGE
DANGER!
The unit must be transported and handled by
skilled personnel trained to carry out this type of
work.
IMPORTANT!
Be careful to avoid damage by accidental collision.
II.4.1 PACKAGING, COMPONENTS
DANGER!
Do not open or tamper with the packaging before
installation. Do not leave the packaging within
reach of children.
ENVIRONMENTAL PROTECTION
Dispose of the packaging materials in compliance
with the national or local legislation in force in your
country.
The TCAEY-THAEY 115÷130 models are supplied:
• in cardboard packaging.
• protected above by a wooden frame;
• fixed to a pallet by 4 screws;
• tied down by two straps;
TCAEY – THAEY 115÷130
The TCAEY-THAEY 133 model is supplied:
• fixed to a pallet by 4 screws;
• covered with nylon shrink-wrap.
TCAEY – THAEY 133
Each unit is supplied complete with:
• Instructions for use;
• Wiring diagram;
• List of authorised service centres;
• Warranty document;
• Use and maintenance manual for the pumps, fans and safety valves.
SECTION II: INSTALLATION AND MAINTENANCE
II.4.2 LIFTING AND HANDLING
DANGER!
Movement of the unit should be performed with
care, in order to avoid damage to the external
structure and to the internal mechanical and
electrical components.
Also make sure that there are no obstacles or
people blocking the route, to avoid the danger of
collision or crushing. Make sure that there is no
possibility of the lifting-gear overturning.
The unit is supplied on a wooden support structure. This structure
serves to facilitate unit transport using a forklift or a hand truck. Use this
method to transport the unit to the installation position.
On arrival at the final installation site, remove the wooden substructure
(unscrew the 4 screws). Pass the straps through the slots in the base of
the unit, having first checked their suitability (as regards their strength
and state of wear and tear). Take the strain on the slings, checking that
they remain properly attached to the lifting-hook; lift the unit a few
centimetres, then, only after checking the stability of the load, slide the
pallet out, taking care not to trap any parts of the body, in order to
eliminate any possible risk of crushing or any other injury if the load
drops or shifts suddenly. Carefully carry the unit to the installation site.
Lower the unit carefully and fix it into place.
26