Descargar Imprimir esta página

Craftsman 139.30437 Manual Del Propietário página 31

Ocultar thumbs Ver también para 139.30437:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
llVlPORTANT S AFETYiNSTRUCTiONS
To reducethe risk of SEVERE iNJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND iNSTRUCTiONS.
2. ALWAYSkeep remote controls out of reach of children.
NEVERpermit children to operate or play with garage door
control push buttons or remote controls.
3. ONLYactivate garage door when it can be seen clearly, it is
properly adjusted, and there are no obstructions to door
travel.
4. ALWAYSkeep garage door in sight and away from people
and objects until completely closed. NOONESHOULD
CROSSTHE PATHOFTHE MOVINGDOOR.
5. NO ONESHOULDGO UNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. if possible, use emergency release handle to disengage
trolley ONLYwhen garage door is CLOSED.Use caution
when using the releasewith the door open. Weak or broken
springs or unbalanced door could result in an open door
failing rapidly and/or unexpectedly, and increasing the risk of
SEVEREINJURY or DEATH.
7. NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
8. NEVERuse handle to pull garage door open or closed, if
rope knot becomes untied, you could fall.
9. After ANY adjustments are made, the safety reversal
system MUST be tested.
10. Safety reversal system MUST be tested every month.
Garage door MUST reverse on contact with 1-1/2" high
(3.8 cm) object (or a 2x4 laid flat) on the floor. Failureto
adjust the opener properly increases the risk of SEVERE
INJURYor DEATH.
11. ALWAYS KEEPGARAGEDOORPROPERLYBALANCED
(see page 3). An improperly balanceddoor may NOT
reversewhen required and could result in SEVEREINJURY
or DEATH.
12. ALL repairs to cables, spring assemblies and other
hardware, ALL of which are under EXTREME tension,
MUST be made by a trained door systems technician.
13. ALWAYSdisconnect electric power to garage door opener
BEFORE making ANY repairs or removing covers.
14. This operator system is equipped with an unattended
operation feature. The door could move unexpectedly. NO
ONESHOULDCROSSTHE PATH OFTHE MOVINGDOOR.
15. DONOT enable the Timer-to-Close functionality if operating
either one-piece or swinging garage doors. To be enabled
ONLYwhen operating a sectional door.
16SAVETHESE INSTRUCTIONS.
Features
Your garage door opener is equipped with features to provide you
with greater control over your garage door operation.
TIMER-TO-CLOSE
The Timer-to-Close feature automatically closes the door after a
specified time period that can be adjusted using the door control.
Prior to the door closing there will be an audible and visual alert.
ASSURELINK
TM
AssureLink
TM
technology uses a 900MHz signal to provide
two-way communication between the garage door opener and
AssureLink
TM
accessories. Your garage door opener is compatible
with up to 8 AssureLink
TM
accessories.
ASSURELINK
TM
REMOTECONTROLS AND DOORCONTROLS
Your garage door opener has already been programmed at the
factory to operatewith your remote control, which changes with
each use, randomly accessing over 100 billion new codes. Older
Craftsman accessories are not compatible.
Up to 8
Up to 2 AssureLink
TM
door controls.
Upto 1
31
THE PROTECTOR SYSTEM ®(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing
sensors will detect an obstruction in the path of the infrared
beam. if an obstruction breaks the infraredbeam while the door
is closing, the door will stop and reverse to full open position,
and the opener lightswill flash 10 times, if the door isfully open,
and the safety reversing sensors are not installed,or are
misaligned, the door will not close from a remote control.
However, you can close the door if you hold the button on the
door control or keyless entry until the door is fully closed. The
safety reversing sensors do no effect the opening cycle.
ENERGYCONSERVATION
For energy efficiency the garage door opener will enter sleep
mode when the door is fully closed. The sleep mode shuts the
garage door opener down until activated. The sleep mode is
sequenced with the garage door opener light bulb; as the light
bulb turns off the sensor LEDs will turn off and whenever the
garage door opener lightsturn on the sensor LEDs will light.
The garage door opener will not go into the sleep mode until the
garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener
is initiallyplugged in; power is restored after interruption, or
when the garage door opener is activated. The lights wiii turn off
automatically after 4-1/2 minutes. An incandescent A 19 light bulb
(100 watt maximum) or for maximum energy efficiency a 26W
(100W equivalent) compact fluorescent light (CFL) bulb may
be used.

Publicidad

loading