Craftsman 139.30437 Manual Del Propietário página 34

Programming
Your garage door opener has been programmed at the factory to operate with your remote control. Older Craftsman_ accessoriesare
not compatible, see page 40 for compatible accessories. Programming can be done through the door control or the learn button on
the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls.
IMPORTANTNOTE:If your vehicle is equipped with a Homefinl_, you may require an external adapter depending on the make, model
and year of your vehicle. Vis# www.homefink.com for additional information.
PROGRAMA REMOTEUSINGTHE LEARNBUTTON
TO ADD, REPROGRAIVI, ORCHANGEA REMOTECONTROL/
KEYLESS ENTRYPiN USINGTHE MOTION-DETECTING
CONTROLPANEL
(
1. Press and releasethe Learn button on
the garage door opener. The Learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
3. Releasethe button when the garage
door opener light blinks. It has learned
the code. if light bulbs are not installed,
two clicks will be heard.
When replacing the light lens cover, ensure the antennawires are
hanging straight down.
ToErasethe Memory
1. Press the LEARN button on the door [ The command
LED ]
control to enter Programming Mode.
/ will
flash once.
/
2. Press the LEARN button again, the LED
will flash once.
3. Press the button on the remote control
that you wish to operateyour garage
door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad.Then press the
ENTERbutton.
The garage door opener lights will flash
(or two clicks will be heard) when the
code has been programmed.
Repeat the steps above for programming
additional remote controls or keyless entry
devices.
The command LED
will flash once again.
OR
? ? ? ?
ERASEALL REMOTECONTROLS AND I{EYLESSENTRIES
1. Press and hold the learn button on garage door opener until
the learn LEDgoes out (approximately 6 seconds). All remote
control and keyiess entry codes are now erased.
Reprogram any accessory you wish to use.
ERASEALL DEVICES(INCLUDINGASSURELINK
TM
ACCESSORIES)
1. Press and hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LEDgoes out. All codes are now erased.
Reprogram any accessoryyou wish to use.
34