Publicidad
Idiomas disponibles
Idiomas disponibles
Selection of battery charger
! ATTENTION: check that the battery charger is
compatible with the batteries being charged.
Tubular lead-acid (wet) batteries: an electronic battery
charger is recommended. In any event, contact the
external battery charger is suitable.
for this type of battery.
Preparing the battery charger
! ATTENTION: authorized service technician required
to perform this procedure.
When using a battery charger not provided with the
the machine equipment package.
The connector supplied for the external battery charger is
suitable for cables with maximum cross-section 16 mm2
remove around 13 mm of the protective sheath from the
red and black conductors of the battery charger cable;
attach the ends to the contacts of the connector and
squeeze forcibly with suitable crimping pliers;
make certain the polarity is correct (red + black –) when
attaching the wires to the connector.
Fitting the side brush
! ATTENTION: before carrying out the operations
apply the parking brake.
Assembly:
-
Undo the screw on the motor shaft.
-
Check that the drive key is located in the keyway
of the motor shaft.
-
motor shaft.
-
Retighten the clamp screw.
Disassembly:
-
Repeat the steps described above in reverse
order.
EN
16
Publicidad
