Tennant S880 Manual De Instrucciones página 26

- Remove the adapter from the core of the old brush
bristles aligned in the same direction.
- Fit the new brush and make sure that the adapter
is coupled to the drive hub.
- Replace the brush compartment cover, repeating
the disassembly operations in reverse order.
Adjusting the centre brush for wear
Correct adjustment of the centre brush will ensure better
quality cleaning in less time.
Make the adjustment when the brush has become worn.
Proceed as follows:
- Raise the brush.
- Unscrew the knob.
- Turn the adjuster anti-clockwise until the knob is
- Retighten the knob.
! NOTICE
Once all six of the adjustment positions have been
used up, proceed with replacement of the brush as
Adjusting the side brushes for wear
! ATTENTION: before carrying out the operations
apply the parking brake.
due to excessive wear, they can be adjusted as follows:
- Lower the side brushes by pulling the relative
levers out and easing them down.
- Loosen the adjustment screws.
- Position the brush by hand, as required.
- Tighten the adjustment screws.
EN 26