Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
INSTRUCTIONS
23
Connecfin
9 gas
dryers
(conf.)
AWARNING
To reduce the risk of fire, electric shock, or injury to persons when
using this appliance,
follow
basic precautions,
including
the
following:
. Installation
and service must be performed
by a qualified
installer, service agency,
or the gas supplier.
Failure to do so
can result in fire, explosion,
or death.
. Use only a new stainless steel flexible
connector
and a new
AGA-certified
connector.
Failure to do so can result in fire,
explosion,
or death.
. A gas shutoff valve must be installed
within
6 ft. (1.8 m) of
the dryer.
Failure to do so can result in fire, explosion,
or death.
. The dryer
is configured
for Natural
Gas when shipped
from
the factory.
Make sure that the dryer is equipped
with the
correct burner orifice
for the type of gas being
used (Natural
Gas or Liquefied
Petroleum).
Failure to do so can result in fire,
explosion,
or death.
. If necessary,
the correct
orifice
(for the LP, orifice
kit order
part number
383EEL3002D)
should
be installed
by a
qualified
technician
and the change should be noted
on the
dryer. Failure to do so can result in fire, explosion,
or death.
. All connections
must be in accordance
with local codes and
regulations.
Failure to do so can result in fire, explosion,
or
death.
. Gas dryers MUST exhaust
to the outdoors.
Failure to do so can
result in fire, explosion,
or death.
Connecting the Gas Supply
1 Make sure that the gas supply to the laundry room is turned
OFF.Confirm that the type of gas available in your laundry room
is appropriate for the dryer. The dryer is prepared for Natural
Gaswith a s/8 - inch NPT gas connection.
2. Remove the shipping cap from the gas connection at the back
of the dryer. Be careful not to damage the threads of the gas
connector when removing the shipping cap.
3. Connect the dryer to your laundry room's gas supply using a
new flexible stainless steel connector with a s/8 -inch NPT fitting.
4. Securely tighten all connections between the dryer and your
laundry room's gas supply. Turn on your laundry room's gas
supply and check all pipe connections (both internal and
external) for gas leaks with a noncorrosive leak-detection fluid.
Electrical
Connection
Plug dryer into a 120 VAC, 60
Hz grounded 3-prong outlet.
1/8" NPT Pipe
3/8" NPT Gas
Plug
Connection
Supply
AGA/CSA-Certified
ShutoffValve
Stainless Steel Flexible
Connector
High-Altitude
Installations
The BTU rating of this dryer is AGA-certified
for elevations
below
10,000 feet.
If your gas dryer is being installed
at an elevation
above 10,000
feet, it must be derated
by a qualified
technician
or gas supplier.
Publicidad
