48
OPTIONAL
ACCESSORIES
OPTIONAL
ACCESSORIES
Slacking
ki'l" insfallafion
This stacking
kit includes:
.Two (2) side rails
. One (1) front rail
. Four (4) screws
1. Make sure the surface of the washer is clean and dry. Remove
paper backing
from the tape on one of the stacking
kit side
brackets.
Tools Needed for Installation:
. Phillips screwdriver
To ensure safe and secure installation,
please observe the
following
instructions.
WARNING
. Incorrect
installation
can cause serious accidents.
. The weight
of the dryer and the height of installation
make
this stacking
procedure
too risky for one person.
Two or
more people are required
when installing
the stacking
kit.
There is a risk of serious back injury or other injuries.
. Do not use the stacking
kit with a gas dryer in potentially
unstable conditions
such as a mobile
home. Failure to follow
this warning
can result in serious injury.
. Place the washer on a solid, stable, level floor
capable
of
supporting
the weight
of both appliances.
Failure to follow
this warning
can result in serious injury.
. Do NOT stack the washer on top of the dryer. Failure to follow
this warning
can result in serious injury.
. If appliances are already installed, disconnect them from
all power, water, or gas lines and from draining or venting
connections. Failure to do so can result in electrical shock, fire,
explosion, or death.
2. Fit the side bracket to the side of the washer top as shown in
the above illustration.
Firmly press the adhesive area of the
bracket to the washer surface. Secure the side bracket to the
washer with a screw on the back side of the bracket. Repeat
steps 1 and 2 to attach the other side bracket.
c