Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION! Electric shock warning!
ATTENTION! Hot surface, risk of burns!
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details may
differ from the actual product.
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Infrared Sauna Room
2.1.
Electrical safety
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and
a)
matching sockets reduces the risk of electric shock.
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
b)
increased risk of electric shock if the earthed device is exposed to rain, comes into direct
contact with a wet surface or is operating in a damp environment. Water getting into the
device increases the risk of damage to the device and of electric shock.
Do not touch the device with wet or damp hands.
c)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug
d)
out of a socket. Keep the cable away from heat sources, oil, sharp edges or moving parts.
Damaged or tangled cables increase the risk of electric shock.
Do not use the device if the power cord is damaged or shows obvious signs of wear. A
e)
damaged power cord should be replaced by a qualified electrician or the manufacturer's
service centre.
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do
f)
not use the device on wet surfaces.
Prevent the device from getting wet. Risk of electric shock!
g)
Before the first use, please check whether the main voltage type and current comply with the
h)
indicated data on the type plate.
The electrical installation to which the device will be connected should be equipped with a
i)
residual current device (RCD).
The electrical socket to which the device will be connected must have a grounding wire.
j)
Do not use extension cords when assembling the sauna.
k)
Water should not be sprayed on the outside of the sauna. If the ground is damp, install a
l)
floor separator to isolate the sauna from moisture.
All electrical components must be connected by a qualified electrician with valid permissions.
m)
To avoid burns or electric shock, do not touch or use any metal tools on the mesh cover that
n)
protects the heating element.
Do not install showers or other water-spraying devices near the sauna.
o)
Do not install an electrical socket inside the cab. Do not install any type of locks or screws.
p)
EN
Publicidad
