Safety Features; Unpacking And Set Up; Water Requirements - La San Marco OC OI Manual De Uso

3. SAFETY FEATURES
The brewer is equipped with a series of safety features:
- Internal fuses located on main electronic board.
- Capsule lid sensor stops brewer if opened.
- Brewer stops asking for capsule drawer to be emptied every 20 brews. Please follow "Care
and Maintenance" instructions for details.
- Water boiler sensor with logic to keep brew temperature under control and alerts user in case
of malfunction.
- Overload switches installed on internal pumps to cut off power in case of over-heat.
- Water reservoirs sensor to alert in case of water supply issues and avoid damage to the pumps.
Please refer to the "Troubleshooting" (9) section for details on problems and solutions.
4. UNPACKING AND SET UP
Save all the packaging, documentation and warranty card provided with the brewer for future use.
- Place the box upright on a large surface and open the box from the top.
- Reach into the box and remove cover foam that protects the Brewer.
- Remove plastic cover from brewer and save the Electrical Manufacturing Certification provi-
ded by La San Marco.
- Grab the brewer from the bottom, paying attention not to pull the drawer's cup tray.
- Place brewer on a large and solid surface.
- Pull the drip tray out and remove any accessories.
WATER REQUIREMENTS
Water represents about 98% of the brew; quality of water is crucial to brew quality drinks, and
also plays an important role in how much deposit of calcium, lime or scale will buildup in the
brewer. While formation of deposits is a natural consequence of heating the water, manufacturer
recommends water with hardness between 1.5 and 5gpg (grains per gallon) to help maintain
best performance. Do not use distilled or purified water.
Manufacturer recommends that a filter be installed between the brewer and the municipality,
and periodically maintained; any cost or damage resulting from calcium, lime or deposits
buildups in the brewer is not covered by warranty.
Recommended filters are the Omnipure Q5486, the Bunn EQ-17-TL, or similar.
INLET
OUTLET
7