Publicidad
Idiomas disponibles
Idiomas disponibles
a pipe in a trench that, if not properly supported, may
sag and pinch the blade.
If the pipe is allowed to sag and close the cut, the blade
will be pinched in the kick back zone and a severe kick
back might develop. If the pipe is properly supported,
the end of the pipe will move downward, the cut will
open and no pinching will occur.
Secure the pipe so it does not move or roll during
cutting. Make sure that the cut opens to avoid pinching
the blade.
To cut in smaller pipes
WARNING:
the kickback zone, it will cause a severe
kickback.
If the pipe is smaller than the maximum cutting depth of
the product, the cutting operation can be done in 1 step
from top to bottom.
•
Cut the pipe from top to bottom.
To cut in larger pipes
WARNING:
the kickback zone, it will cause a severe
kickback.
If the pipe is larger than the maximum cutting depth of
the product, and can not be rolled, the cutting operation
needs to be divided in 5 steps.
•
Set the blade guard to pipe cutting mode. Refer to
To set the pipe cutting mode on page 23 .
1960 - 002 - 25.08.2023
If the blade is pinched in
If the blade is pinched in
•
Divide the pipe into 5 sections. Do a mark of those
sections and of a cutting line. Cut a shallow guide
groove around the pipe.
4
1
•
Cut those sections in 5 steps with the cutting
directions shown by the arrows in each step.
•
2
•
3
5
3
2
1
19
Publicidad
