Publicidad
Idiomas disponibles
Idiomas disponibles
Approved service center
To find your nearest Husqvarna approved
service center, go to the web site
www.husqvarnaconstruction.com.
Troubleshooting of the product
Problem
The product does not start. No
LEDs come on when you push
the On/Off button on the prod-
uct.
The product is on, but a warn-
ing indicator or a indicator is on
or flashes.
The product is on but the motor
does not start when you push
the power trigger.
The motor is on but the blade
shaft does not rotate.
An unusual noise comes from
the front bearings.
There are unusual vibrations
when the product is on.
The product makes a sudden
movement when you push the
power trigger, then immediately
stops.
The product stops during a
kickback.
The motor makes sudden
movement when you push the
power trigger, then stops.
The product stops when you
apply work load.
1960 - 002 - 25.08.2023
Service
Troubleshooting
Cause
The battery is damaged.
The plug between the battery and the
product is damaged.
The battery is not correctly installed in
the product.
Servicing is necessary.
There is an error in the product.
Servicing necessary.
The drive belt is damaged or worn.
The bearings are damaged or worn.
There is a short circuit in the control
unit.
The X-Halt function is engaged.
Servicing is necessary.
There is too much work load on the
product.
Solution
Do a test with a different battery.
Make sure that the power connectors
between the battery and the product are
not dirty or damaged.
Remove the battery and install it correct-
ly.
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Replace the drive belt, refer to
move the drive belt on page 28 .
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Speak to an approved Husqvarna serv-
ice center.
Wait for the X-Halt to disengage.
Start the product again and apply less
work load.
To re-
29
Publicidad
