Publicidad
Idiomas disponibles
Idiomas disponibles
•
Make sure that the front ground support is flush
with the work piece at the rear. The blade guard
collects spray and dust and keeps them away from
the operator.
•
Cut with full throttle. Keep full rotating speed until the
cutting operation is completed.
•
Push the cutting blade lightly against the object you
are cutting. Do not use force.
•
Align the cutting blade with the cut.
•
Move the cutting blade slowly forward and rearward
to decrease the area between the cutting blade and
the material. This decreases the temperature of the
cutting blade.
•
Do not cut with the kickback zone of the blade, see
Kickback zone on page 18 .
To set the pipe cutting mode
WARNING:
blade guard can be very hot, use gloves
when you adjust the blade guard.
1960 - 002 - 25.08.2023
The adjustment handle for
WARNING:
during pipe cutting operation. In all other
operations you must use standard cutting
mode
The pipe cutting mode enables pipe cutting in the
kickback zone.
1. Move the stop bolt of the blade guard from the
standard cutting mode (A) to the pipe cutting mode
(B).
A
2. Pull the adjustment handle to enable the pipe cutting
mode.
Only use pipe cutting mode
B
23
Publicidad
