Trumpf TruTool S 160 Traduccion Del Manual De Instrucciones Originale página 16

EN
3.2 Height regulator for moving
cutter blade
S 450
(3A1)
This TRUMPF shears offer the oppor-
tunity to adjust the immersion depth of the
moving cutter blade to the sheet thickness
and cutting task by using a height regulator.
The height regulator snaps in for full steps
and for the intermediate steps, see Setting
the moving cutter blade
Cutting straight lines
Cutting curves
Cutting coils
4 Consumables and
accessories
4.1 Selection of blade
The blades have 2 or 4 cutting edges. These
cannot be reground.
Depending on the thickness or density of the
workpiece, different types of blades are
needed.
With improper blade selection, the following
may happen:
– The cut quality is greatly impaired.
– The feed force increases significantly.
– The blade breaks.
For gentle work and good cutting perfor-
mance, make sure that the blades are sharp,
and that they are changed promptly.
When cutting radii, the following must be
heeded:
– Do not twist the machine.
– Work only at a low feed rate.
16
[} 253].
D
1.0
Translation of the original operator's manual
Fig. 1: Height regulator for moving cutter
blade
Sheet thickness [mm]
1.5 2.0 2.5
For notes about selecting the correct tool, as
well as accessories, spare parts lists for
blades, tools, and rechargeable battery
packs, see:
S 160
(2A5)
S 250 S 250
(3A5) (2A1)
S 450
(3A1)
3.0 3.5 4.0 4.5
–