cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 106

ENGLISH
- Before washing the clothes for the first time, the product shall be operated in one
round of the whole procedures without the clothes inside.
- Make sure that all pockets are empty. Sharp and rigid items such as coins, brooches,
nails, screws or stones may cause serious damage to this machine.
3. PRODUCT INSTALLATION
1. Place the device on a flat, stable and dry surface. Make sure the product does not
stand on the power cord.
2. Never install it on a soft carpet or wooden floor, or on any kind of mezzanine.
3. The washer may move a little during operation due to overload factors.
4. Avoid direct sunlight and ensure sufficient ventilation.
5. Keep the room environment dry and avoid humidity.
6. Remove the cardboard box and Styrofoam packing.
7. Free the power cable and the drain hose from the rear.
8. Remove any accessories that may be inside the drum, such as the water supply hose,
instruction manual, etc.
9. The washing machine should be operated within a temperature range of 5-40 °C. If
used under 0°C, the inlet valve and draining system may be damaged.
10. Install the appliance ensuring sufficient space around it (Fig. 4):
a: minimum 3 cm.
b: minimum 5 cm.
c: minimum 5 cm on the left side.
d: minimum 5 cm on the right side.
e: minimum 70 cm.
WARNING: Do not allow metal parts of the appliance to come into contact with metal sinks
or other appliances.
Removing the transport screws (Fig. 3)
- The transport bolts must be removed from the backside of the device before using it.
- IMPORTANT: it is imperative to remove the transport screws before the first use,
otherwise they may damage the drum during the operation of the device.
- The transport screws will be necessary again when moving the product, so make sure
they are kept in a safe place.
- In order to remove the screws:
106 BOLERO DRESSCODE 9800 INVERTER A/ STEEL