cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 131

Excessive noise
The machine is continuously
filled with water and
continuously emptied.
The drained water returns to
the apparatus
Control panel gets hot
General issues
- Do not repair or replace any part of the appliance unless specifically instructed to do
so in this instruction manual. It may lead to a dangerous incident that endangers your
health and/or damages property.
- In case of fault or malfunction, contact the official Technical Support Service of Cecotec.
- Use original spare parts.
- IMPORTANT: do not come into contact with the following internal components while the
appliance is connected: inlet valve(s), drain pump, motor controller heat sink, PCB.
There will always be some noise from the motor, pump and
drum during spinning.
The washing machine touches other objects.
Foreign objects, such as hairpins or metal objects, fall into the
drum.
The top of the drain hose is too low. It should be installed at a
height of 65-100 cm from the ground.
The end of the drain hose has been pushed too far down into
the standpipe; the hose elbow must be installed 100 mm from
the end of the drain hose.
The end of the drain hose is submerged in the discharged
water.
If the end of the drain hose touches the discharged water
(water drained from the washing machine), it (the discharged
water) may be sucked back into the appliance and damage the
appliance or garments.
This is a slight heating effect of the electronic components on
the PCB board installed on the back of the control panel.
Your appliance contains sensors that monitor progress during
the wash cycle (e.g. water level, temperature, unbalanced
loads, wash time/progress). Normally, if your appliance
completes the cycle successfully, it is unlikely that there will
be a problem.
BOLERO DRESSCODE 9800 INVERTER A/ STEEL
ENGLISH
131