Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions:
1
Remove loose soiling from the surface you wish to clean (brush or vacuum clean)
2
Turn the rocker lever into the vertical position to activate the (cleaning) liquid in the bottle.
3
Pls. note to insert the cleaning liquid just before application and remove remaining
liquid after use to avoid that the hoses and the suction filter get choked by chemical
residues.
Do not use cleaning agents which are acidic, alkali and/or inflammable. We recommend
the use of neutral cleaning agents.
4
Connect the tool to you compressed air supply.
5
Important: Hold the cleaning spout at a distance of only 1-3 cm from the surface you are
cleaning and in angle of approx. 45°.
6
Always make sure, that the rotating parts of the tool will not get in touch with protruding parts
of the surface you are currently cleaning, to avoid damages on both of them.
7
Press the "trigger" all the way; move the Tornador Gun slowly with circular motions over the
surface you are cleaning.
8
Turn the rocker lever into the horizontal "air only" position, press the trigger and dry the
surface you have cleaned.
9
To remove any remaining moisture, wipe the cleaned surface with a dry cloth.
CARE AND MAINTENANCE after use
•
Clean the spout as follows: Turn the control switch to the horizontal "air only" position, hold the
cleaning nozzle in a bucket and press the trigger all the way in order to remove any soiling
from the nozzle.
•
Additional you need to flush the hoses and the suction filter after every use. For this
please insert pure water in the empty and clean cup and attach it to the unit as usual.
Turn the rocker lever into the vertical position and press the trigger for at least 20
seconds to flush and clean the related parts. If needed clean the suction filter
separately by pulling of the metal-ball from the suction hose and using an air blow gun
to clean the integrated filter.
•
Replace damaged parts immediately for your own safety. The rotate-set, nozzle, hoses and
gaskets are consumable parts. Pls. ask your local supplier for related original-spare parts.
•
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply,
when not in use, before changing accessories or when making repairs.
REQUIRED AIR RATE
To perform to its full potential, the TORNADOR® Black requires a constant air pressure between 4.5
and 6.5 bar (65 to 94 psi).
CAUTION: Constant air rates vary depending on the size and power of the compressor. Always make
sure that the tank and the air hoses are free of impurities of any kind.
Vers.2023/01
13
Publicidad
