Publicidad
PONT DE VAUX
(FRANCE) SITE
NAVIPASS Modbus
The NAVIPASS Modbus is a bypass that allows a boiler equipped with a NAVISTEM
B2000, NAVISTEM B2100 and RVS63, NAVISTEM B3000, a gas water heater
equipped with a Navistem H3100 or a heat pump fitted with a Navistem T3100
controller, with a boiler room manager PLC.
1. WARNINGS AND RECOMMENDATIONS
1.1. Storage
The NAVIPASS Modbuses:
- must be stored in a place where the temperature is between -20°C and +65°C
where the relative humidity between 5 and 95%.
- must be protected from humidity.
1.2. Symbols used in this document
1.3. Safety instruction
Always disconnect the power supply to the boiler and shut off the main gas supply
before carrying out any work on it.
1.4. Installation requirements specified by regulations
The installation and maintenance of the appliance must be done by a qualified
professional, in accordance with regulatory texts and current industry good
practice, and in particular with the national and local standards applying to low
voltage electric systems.
1.5. Environmental compatibility
15.12.2022
INSTRUCTIONS
INSTRUCTIONS
INFORMATION: This symbol draws attention to comments.
Failure to comply with these instructions may cause
WARNING:
electrocution.
This appliance contains electrical and electronic elements which must
not be disposed of with household waste.
Local legislation must be complied with.
KIT
KIT
FR EN ES IT NL TR
Ref.: 059833
076750
00ANO0019-G
51 / 202
Publicidad
