Publicidad
Idiomas disponibles
Idiomas disponibles
8.Troubleshooting
If you have any other questions, please contact our customer service.
Problem
The treadmill
does not work
The running
belt does not
run smoothly
Running belt
skidding
Error messages on electronic meter and elimination methods
Problem
E01
E02
E03
E04
E05
E06
E07
Display
Abnormal
Possible cause
No power
Power is not turned on
Safety lock is not in place
Circuit signal system
cut out
Blown fuse
Insufficient lubrication
Running belt is too tight
Running belt is too loose
Motor belt is too loose
Possible cause
Bad communication
Power assault
No sensor signal
Controller or motor
abnormal
Overload protection
Safety lock is not
in place
System self-check failed
External interference
Method
Plug into socket
Turn on the power switch
Put the safety lock into the lock position
Check the controller input terminal
and signal line
Replace the fuse
Add methyl-silicone oil lubricant
Adjust the tightness of the running belt
Adjust the tightness of the running belt
Adjust the tightness of the motor belt
Method
The signal line is not plugged in,
plug it in again
Power tube breakdown, replace
the electronic controller
The sensor line is not plugged in
properly, plug it in again
The load is too large, replace the
controller and motor
The load is too large, replace the
electric controller
System failure, replace electric
controller
Put the safety lock into the lock
position
Turn off the power switch, and then
power on again after 1 minute
17
Publicidad
