Publicidad
4.3. Flue Installation
Prohibited area for heater flue
*
Verbotene Einbauzone für Abgasführung
*
Zone interdite l'échappement
*
Area prohibita per il condotto del fumo
*
dell'apparecchio
Prohibited area
Di riscaldamento
*
for heater flue
Área prohibida para la salida
*
Verboden gebied voor de afvoer
*
Förbjudet område för värmekanal
*
Fuel refuelling / breather vent
*
Kraftstoffbetankung / Entlüftung
*
Bouchon de ravitaillement en
*
carburant / de mise à l'air
de mise à l'air
Fuel ferruling/
Rifornimento / sfiato del
*
carburante
breather vent
Repostaje de combustible /
*
respiradero
Brandstof bijtanken / ontluchter
*
Bränslepåfyllning / avluftningsventil
*
Figure 10. Flue Restrictions REF. BS EN 1949 / Bild 10. Abgasbeschränkungen REF. BS EN 1949 /
Figure 10. Restrictions d'évacuation REF. BS EN 1949 / Figura 10. Restrizioni per il condotto del fumo – RIF. BS EN 1949 /
Figura 10. Restricciones para la salida de escape, REF. BS EN 1949 / Afbeelding 10. Rookkanaal Beperkingen REF. BS EN 1949 /
Figur 10. Avgasrestriktioner REF. BS EN 1949
Routing
The exhaust outlet must be positioned in such a way that exhaust gases may not enter the vehicle interior or
external living space. The diagram below shows the area where the exhaust flue must not be located.
If the flue is fitted at a distance which is closer to the window than indicated above in Figure 3, a window
circuit-breaker switch must be installed that shuts off the LPG gas supply to the heater when the window is
opened.
Do not route exhaust components within 50 mm of flammable materials such as fuel system components,
polyurethane or similar foam insulation, styrene sheet installation, wood and paper products, carpet, glycol
reservoirs, coolant lines, brake lines, electrical wiring, etc.
The flues must be routed in such a way to prevent liquid build up. See Section 4.3 Step 2 for underfloor in-
stalls, and Section 4.3 Step 3b for onboard installs
The flue terminal must always face outward away from the vehicle.
The flue terminal must be located at the side of the caravan. Acceptable flue lengths are, 0.75 metres,
•
1.25 metres and 2.00 metres.
•
The flue terminal must be positioned at the side of the vehicle, that an awning will never be fitted to.
•
Only the Whale
this Water Heater. This flue must not be positioned within 500mm of a refuelling point or fuel tank breather
outlet or any ventilator from the fuel system(s). The flue terminal must not be fitted within 300mm of a
ventilator for the living space or an opening part of a window.
•
The flue terminal must only be positioned vertically below an open part of a window, if the appliance is
fitted with an automatic shut-off device to prevent operation when the window is open. The flue terminal
must be a minimum of 300mm below the window.
Min 500mm
flue terminal (supplied with this Water Heater) is permitted to be used in conjunction with
®
15
Min 300mm
Min
300mm
Publicidad
