Publicidad
Idiomas disponibles
Idiomas disponibles
Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and
rated capacity. The extension cord should be kept as short as practicable.
4. How to install Drill bit
CAUTION
To prevent accidents, make sure to turn the switch off and disconnect to the plug from the receptacle.
NOTE：
When using tools such as Tine chisel, drill bits, etc., make sure to use the genuine parts designated by
our company.
(1) To attach the drill bit (SDS-plus shank), insert it into the hole until it contacts the innermost end of the
hole as illustrated in Fig.1. If you continue to turn the tool with slight pressure, you can feel a spot where
there is a hitch. At that spot, pull the flex sheath to the direction of an arrow mark and insert the drill bit
all the way until it hits the innermost end. Releasing the flex sheath reverts the flex sheath and secures
the tool in place.
(2) Pull the drill bit to make sure it is locked completely.
(3) To remove the drill bit, fully pull the flex sheath in the direction of the arrow and pull out the drill bit.
5. Regulating the number of rotations and hammering (Fig. 2) This Rotary Hammer is equipped with a
built-in electronic control circuit that can adjust and regulate the number of rotations and times of ham-
mering. This Rotary Hammer can be used by adjusting the speed adjuster knob, depending upon the
contents of operation, such as boring holes into fragile materials, chipping, centering, etc.
The scale'1' of the speed adjuster knob is designed for a minimum speed with the number of 300
rotations per minute and 1950 times of blow per minute. The scale '6' is designed for a maximum
speed with the number of 720 rotations per minute and 4100 times of blow per minute.
CAUTION:
Do not adjust the speed adjuster knob during operation. Doing so can result in injury because the Rotary
Hammer must be held by only one hand, disabling the steady control of the Rotary Hammer.
HOW TO USE THE ROTARY HAMMER
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when
the drill bits and other various parts are installed or removed. The power switch should also be turned
off during a work break and after work.
8
Publicidad
