Publicidad
Idiomas disponibles
Idiomas disponibles
3.1 - DESCRIPTION OF THE RECEIVER
The receiver, once powered, before having associated a TCOO, looks like this:
• POWER LED on (properly powered device);
• The LED RADIO CHECK turned on fixed (no TCOO learned);
• Both L1 and L2 LEDs on (outputs in alarm state).
Once you have learned a TCOO, the RADIO CHECK LED, in its normal functionality, gives immediate feedback of the radio packets
received by its associated transmitters by flashing a short.
The buzzer on the board allows you to have immediate acoustic information on the diagnostics of the associated transmitters,
depending on the number of acoustic signals emitted.
ACOUSTIC SIGNALS
1 -
2 -
4 -
6 -
When the batteries on the transmitter are almost empty and reach the voltage of 2.1V, the receiver warns the user of the imminent
need to replace the batteries by performing 4 beeps every minute. During these reports the system is still working, but it is advisa-
ble to consider whether to proceed to the replacement of the batteries before the automation stop occurs.
In case of no communication with an associated TCOO, the receiver will perform 6 beeps every minute and will bring all its outputs
in alarm state.
3.2 - ADVANCED RADIO CHECK FUNCTION
• Low signal coverage results in increased battery consumption.
The RADIO CHECK function allows to know the quality of the radio communication between a TCOO and an RCOO. This charac-
teristic may depend on the presence of devices that generate radio noise, or phenomena of shielding and reflection due to metal
bodies present in the installation itself.
In this mode the RADIO CHECK LED performs a number of flashes every second proportional to the quality of the radio coverage
at that time. It is therefore advisable to perform some complete movements of the automation so that you can evaluate the overall
quality of radio communication between the devices in your installation.
• To activate the RADIO CHECK mode, move the DIP-SWITCH on the RCOO to the ON position.
• Press a safety edge to start displaying the status of the radio transmission between the TCOO to which that safety edge is
connected and the associated receiver.
LED RADIO CHECK
1 -
2 -
3 -
• Once all the checks are completed, you can return the DIP-SWITCH switch of the RCOO to the OFF position to exit the RADIO
CHECK function.
6-1620173M - rev. 0 - 30/10/2023
DESCRIPTION
Press the TEST button of an associated TCOO.
Input of a TCOO associated in alarm.
Notice of battery replacement of an associated TCOO.
Failure to communicate with an associated TCOO.
WARNING
Low radio coverage.
Medium radio coverage.
Good radio coverage.
ASSOCIATED OUTPUT
Consent
Alarm
Consent
Alarm
DESCRIPTION
Translated from the original language - English - 9
Publicidad
