Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
AND CHECKING
CONTENTS
This drill press will require some amount of assembly,
Remove all of the parts from the shipping box and lay
them on a clean work surface,
Remove any protective matedab and coatings from all
of the parts and the drill press, The protective coatings
can be removed by spraying WD-40 on them and
wiping it off with a soft cloth, This may need redone
several times before all of the protective coatings are
removed compbtely,
CAUTION: DO NOT use acetone,
gasoline or lacquer thinner to remove any protective
coatings on your drill press,
After cbaning, apply a good quality automotive wax to
any unpainted surfaces, Make sure to buff out the wax
before assembly,
Figure
3-1
A
............ /_'_.
Compare the items to Figure 3-1 below; verify that all
items are accounted for before discarding the shipping
box, If there are any missing parts, call Customer
Helpline 1°800°897°7709,
The drill press is a heavy machine, two people may
be required to unpack and lift machine,
if any parts are missing, do not attempt to plug in the
power cord and turn ON the drill press, The drill press
can only be turned ON after all the parts have been
obtained and installed correctly,
B
C
J
K
A,
Drill press head and motor assembly
B,
Table
C, Column, rack and ring
D, Worm gear
E,
Feed handle (S)
F,
Table raise/lower handle
G, Table lock handle
H, Keyless chuck
I,
Base
J,
Laser assembly
K,
Clamp
11
Ddlt Press Hardware:
(not shown)
L,
Hex head cap screw M8-1,25 x 25mm (4)
Mounting
Hardware:
(not shown)
M, Hex head screw M8-1,25 x 125mm (2)
N, Fiat Washer M8 (2)
O, Lock Washer M8 (2)
R
Hex Nut M8-1,25 (2)
Toots Included:
(not shown)
Q, 2,5mm Hex wrench
R, 3mm Hex wrench
S,
4mm Hex wrench
Publicidad
