Publicidad
Idiomas disponibles
Idiomas disponibles
Check that the drive lever (11) is disengaged, and the
gear shift lever (13) is in neutral position "0" to avoid
a sudden and uncontrolled movement while starting the
engine.
1. Move the choke lever (22) to "CLOSE" position, until it is
left positioned;
2. Open the fuel tap (22) and put it in the "ON" position, the
knob should be right positioned;
3. Place the throttle knob (8) in the middle position;
4. Pull the recoil starter (24) slowly until you feel some
resistance and then pull the recoil starter tightly until
the engine starts running;
5. After about 30 seconds, move the choke lever (22) to
"OPEN "position, to the right.
Do not set the choke lever to "CLOSE" position if the
engine is warm or air temperature is high.
1. Press the safety lever (10);
2. Press the drive lever (11) and the drive shaft starts to
turn;
3. When you release the drive lever, the drive shaft
automatically stops.
To engage the drive shaft
To stop the drive shaft
1. The gear shift lever (13) must be handled when the drive
lever is loose;
2. The gear shift lever allows you to select four positions
according to the desired operation: Reverse "-1", Neutral
"0", Slow "1" and Fast "2";
3. After setting the speed, press the drive lever (11) and the
drive shaft starts rotating.
Start-up movement can be quite abrupt.
Using the throttle adjustment knob (8), you can adjust the
speed of the combustion engine.
Set the speed between "SLOW" and "FAST" according to
your desired speed.
"FAST"
"SLOW"
"
Publicidad
